Carburetor Intake Flange Boot Set For Yamaha Vmax VMX1200 85-07 1FK-13597-00-00

Removing the OEM seals were harder than I expected. However, installing these new ones were WAY easier than I expected! The new clips lined up perfectly, even though I didn't hear all of the clicks. They are firmly in place and look great.

The quality and fitment was on par with OEM. It was an easy install with no issues.

Someone contacted me about removing the original grille with a more aggressive one, I suggested this Honeycomb Mesh grille; once ordered, it was deliver in a day or two, I immediately installed it. Installation was easy. Vehicle looks amazing. Amazon with the WIN again.

Grill looks great! The instructions could have been much clearer and the 3 wire plug had issues that caused a short, but I was able to figure it out.

Lovely fit

Better than expected. Hope the plastic holds through gusty winds.

Looks amazing

These are the larger emblems meaning the original size that comes on Hellcat durangos at 4 inches. These are not the same size at chargers and challengers. Get some fishing line, goo gone for autos and a heat gun. It takes time to remove the old adhesive but these emblems look amazing

I install the unit exactly as the picture shows and my truck worked perfectly. For context I had swapped a battery and while tightening the negative terminal I accidentally touched the butt of my ratchet to the first sub-terminal the one responsible for power steering. So my battery worked great but I shorted out my 175amp fuse on the battery distribution fuse box. GM wanted $120-$140 for the part this $35 replacement works great so far I will update if there are any issues BTW I'm buying a GM OEM part just in case as a back up to carry with me just in case this fails me. Fingers crossed boys fingers crossed.

Yes Great

Product looks good, fit perfectly, unfortunately each tab, one per side, slides into a slot on the bumper and without the tab to fall in place, the once I just flaps around. Only option was either return or drill a small hole and zip tie. I just wanted to finish up and close the hood, not d around swapping old one again. Not happy fundamentally since it's brand new and it should not be broken, however my time is more important to me and these things happen, it's just molded plastic, for the price, I'll take it and will recommend because this product due to fit being perfect and being surprisingly rigid and sturdy after put inplace and secured in. Not to mention the fact that I'm sure the company would have sent me a new one had I asked. There's something nostalgic about zip ties in installations anyway. Throw back to my younger years. Thanks for a hot looking grill my dudes!

Fits nice, easy to install. Looks great. No complaints.

This grill fit perfectly. The brace piece only has one hole so I drilled a second hole like the original just to make sure it was tight and secure. Also, you can pop out your Mercedes emblem, and snap it into this grill very easily. I popped mine out of the old grill, painted it gloss black, and snapped it into the new grill.

Extremely high quality! all necessary parts and looks great!

Nice