Bloque de texto
Perilla de entrada de CA 220 V, interruptor regulador de velocidad del motor de 20 A y CC 220 V
Perilla de entrada de CA 220 V, interruptor regulador de velocidad del motor de 20 A y CC 220 V
No se pudo cargar la disponibilidad de retiro
Perilla de entrada de CA de 220 V, controlador de velocidad de motor de CC, interruptor regulador, motor de CC de 220 V
Detalles específicos:
Condición: 100% nuevo
Voltaje de entrada: CA 220 V
Voltaje de salida: Linealidad bajo carga
Corriente máxima: 20 A
Corriente persistente: 10 A (trabajo a largo plazo)
Rango de velocidad: 0-100%
Protección contra sobrecarga: Sí
Método de regulación de velocidad: Potenciómetro (270 grados con interruptor)
Tamaño: 85 * 58 * 38 mm / 3,34 * 2,28 * 1,49 pulgadas
Nota:
1. Este controlador solo es adecuado para motores de CC de 220 voltios.
2. Permita una diferencia de 1-3 mm debido a la medición manual.
3. Antes de conectar el cableado, observe claramente la etiqueta del mismo y compruebe que la entrada de CC tenga polos positivo y negativo. Los polos positivo y negativo de la fuente de alimentación de CC no se pueden invertir; de lo contrario, el regulador se dañará.
El paquete incluye:
1x controlador de velocidad
Garantía:
Periodo de garantía: 1 año
Devoluciones y reembolsos: Los clientes pueden devolver los productos dentro de los 60 días posteriores a la recepción y procesar un reembolso rápido en un día.
Soporte las 24 horas: Le brindamos soporte posventa oportuno.
Compartir

This carburetor fits my Massey Ferguson tractor perfectly! Super cheap and fixed my old carb’s issues. Installed in minutes, fired right up. Tuning was easy with the adjustment screw. Been on a month—survived freezes, fuel lines still soft. Great quality, happy with it!
First time buying these fuel injectors for my John Deere—great quality! O-rings seated perfectly, no leaks or issues since installation. Engine fires strong now, price is awesome. Will absolutely choose this brand again!
This valve is just the thing for switching air/argon on my Primeweld ct520d for switching between plasma cutting and Tig welding. Needed to reverse the handle for clearance, so it's not intuitive which way the valve is open, hence the markings on the box. Left quick release hose is air in. Clear hose on the right is gas in, bottom clear hose goes to the welder, the red hose goes to the gauge on the welder. Used a double male connector to attach the valve to the air dryer, and the setup is sturdy enough to switch the valve one handed.
Exactly as described. Thanks